WinPilot can Now Link Password of the Ipaq 5400 Series

In the tradition of innovation and program enhancement, WinPilot Version 4.13 can now use the serial number of the Ipaq 5400 series for the password link.

Richard

Hello i have a probleme, my ipaq 5450 FR not start winpilot , he say ' connecting gps' and after only a soft reset to restart my ipaq !

do you have a solution

jean-michel

Jean

First some questions.

What version of WinPilot do you have WinPilot ADV or PRO and Version Number 4.13? ? What kind of GPS?

Richard www.craggyaero.com

Richard www.craggyaero.com

Hello

i have the same probleme with winpilot ADV, ADV simu, PRO , PRO simu : When i start the program, stop on the first gray screen , he don't go to the map screen and the ipaq is block, i must make a soft reset to use it

i use the version is 4.13

i have a licence for navman and a licence for volkslogger

it is impossible to change the licence type because the program don't go to the map screen

Jean-michel

PS : i use a ipaq 5450 french

Jean-michel

Excuse me for my english

Try removing WinPilot (start/settings/system/remove programs) - remove both ADV and PRO. Reinstall one of them and see if it works - start it in symulator mode - that is a way to input the password. Hope it helps.

Andy

i have always the same problem .

start up simulator program first - enter password as blank or just press ok, otherwise use IPAQ serial number.
Simulator should open and display Minden airspace. Select COM PORT menu option and enter correct com port - if using a Navman sleeve or anything connected to bottom of IPAQ use COM PORT 4, 56700 baud.
Close SImulator and open up winpilot....any other queries (including step by step procedure) just email This e-mail address is being protected from spam bots, you need JavaScript enabled to view it

Cheers,
Andy

I have also heard about cracked version of Winpilot ADV available for trial - could be worth hard-resetting your IPAQ and installing this...email for details..

Cheers,
Andy